Install The Interface Board And Harness - Ricoh A109 Service Manual

4.2.4 Install the interface board and harness

[C]
[A]
[F]
1. If the DJF is equipped on the copier, remove the DJF.
If the Film Projector Unit is installed on the copier, remove the mirror unit.
2. Remove the two screws [B] at the front of the scanner unit.
3. Remove the two screws [C] at the rear of the scanner unit.
4. Open the scanner unit and set the scanner support bar [D] as shown.
5. Disconnect the shielded flat cable [E] and remove the IPU board cover [F]
(2 long and 5 short screws).
6. Remove the harness cover [G] from the right rear corner.
7. Remove the lower left cover [H] (4 screws). Then remove the cap [I] from
the lower left cover.
Controller Interface Kit Type-A
[B]
[G]
[E]
[D]
7
[H]
[I]
A109