Paper Feed Clutch, Pick-Up And Separation Roller Solenoid Replacement (1St, 2Nd And 3Rd Feed Unit) - Ricoh A109 Service Manual

6.2 PAPER FEED CLUTCH, PICK-UP AND SEPARATION
ROLLER SOLENOID REPLACEMENT (1ST, 2ND AND 3RD
FEED UNIT)
[A]
1. Turn off the main switch and unplug the machine.
2. Remove the following covers.
•
Upper rear cover
•
Lower rear cover
•
Lower front cover [A]
3. Pull out all paper trays.
4. Remove the used toner tank with the lower right cover [B] on (2 screws
and 2 connectors).
5. Open the paper feed door [C].
6. Disconnect the 3P connector [D] from the paper feed control board [E].
7. Disconnect the 2P connector (orange wires) from the intermediate
connector. Release wires from clamps.
8. Remove the vertical guide plate [F] (2 screws) by sliding to the left.
NOTE: Disconnect wires & release all the harness from clamps when
removing the vertical guide plate.
A109
[C]
[E]
[D]
5-40
Rev. 7/94
[B]
[F]
FSM