Stopper Solenoid Replacement - Ricoh A109 Service Manual

6.9 STOPPER SOLENOID REPLACEMENT

[C]
[D]
[B]
1. Remove the feed-in unit. (Refer to Feed-in Clutch Replacement)
2. Remove the bracket [A] with the stopper solenoid (2 screws).
3. Replace the stopper solenoid [B] (2 screws).
NOTE: When installing the stopper solenoid, pay attention to the
following points:
1) The spring [C] must be correctly hooked to the stopper [D],
as shown.
2) Manually pull the stopper solenoid plunger to confirm that the
press rollers firmly contacts the pick-up rollers. When the
pick-up rollers are manually rotated, the press rollers also
rotate. If not, adjust the stopper solenoid position.
NC5006
[A]
[C]
[D]
7-29 FSM