Belt Drive Motor Replacement - Ricoh A109 Service Manual

6.7 BELT DRIVE MOTOR REPLACEMENT

[B]
[A]
1. Remove the DJF from the copier (2 screws, 2 connectors, 2 hooks) and
place it on a stable place.
CAUTION: Before disconnecting the connectors, turn off the main
switch of the copier.
2. Remove the motor cover [A] (3 screws).
3. Remove the DF main control board cover [B] (4 screws).
4. Remove the transport belt. (Refer to the The Transport Belt
Replacement.)
5. Remove the right cover [C] (4 screws).
6. Remove the belt guide assembly [D] (6 screws).
NOTE: After re-installing the belt guide assembly, confirm the DJF
height (Refer to the procedure 9 of the Installation Procedure.)
A109
[D]
7-24
[C]
FSM