Ricoh A109 Service Manual page 358

CONTROLLER INTERFACE KIT TYPE-A
1. SPECIFICATIONS ..........................................................................1
2. COMPONENT LAYOUT .................................................................1
3. ELECTRICAL COMPONENT DESCRIPTION................................2
4. INSTALLATION ..............................................................................3
4.1 ACCESSORY CHECK ................................................................................... 3
4.2 INSTALLATION PROCEDURE ..................................................................... 4
4.2.1 Remove the Covers............................................................................... 4
4.2.2 Attach the PTL (Pre-Transfer Lamp) to the Belt Cleaning Unit ............. 5
4.2.3 Route the PTL Harness and Attach the Belt Cleaning Unit ................... 6
4.2.4 Install the Interface Board and Harness ................................................ 7
4.2.5 Replace ROM's and Reassemble the Machine................................... 11
4.2.6 Connect To the Fiery and Adjust the Printer Gamma.......................... 11
5. ADDITIONAL SP MODE TABLE FOR PRINTER .......................15
TABLE OF CONTENTS