Scanner Wire Replacement - Ricoh A109 Service Manual

4.11 SCANNER WIRE REPLACEMENT

[B]
[D]
[A]
-Removal-
1. Perform steps 1 to 6 of the scanner motor replacement section.
2. Remove the right operation panel supporting bracket [A] (4 screws).
3. Lift up the Scanner Unit (See Optical Housing Unit Replacement Section)
and remove the left operation panel supporting bracket [B].
4. Remove the screw [C].
5. Lower the scanner unit and remove the front scanner frame [D] (5
screws).
6. Loosen the front and rear brackets [E] securing the wire to the 1st
scanner as shown in the figure.
7. Loosen the bracket fixing screw [F] and the adjusting screws [G].
8. Remove the tension spring [H] located at the left side and remove the
scanner wires.
A109
[C]
[H]
5-28
[E]
[G]
[F]
FSM