Vertical Registration Adjustment; One Sided Original Mode - Ricoh A109 Service Manual

6.10VERTICAL REGISTRATION ADJUSTMENT

6.10.1 One Sided Original Mode

[C]
1. Remove the small cover at the rear side on the upper DJF cover.
2. Turn on DIP-SW No. 101-2, 4 and 102-4.
3. Set a sheet of A4 / 8 1/2" x 11" (53 ~ 80 g/m
on the original table.
4. Push SW 101 [A].
5. After the original stop on the exposure glass, gently raise the DJF so that
the original does not move.
6. Confirm that the gap between the trailing edge of the paper and the
original left scale [B] is within 2 mm.
7. It the gap is larger than 2 mm, adjust the registration by turning VR101
on the DJF main board.
NOTE: 1. Before setting the original on the original table again, open
and close the feed unit cover [C].
2. After completing the adjustment, return the DIP switches to
the original condition.
A109
[B]
/ 14 ~ 22 lb)sideways paper
2
7-30
Rev. 7/94
[A]
0 ~ 2 mm
FSM