Feed Roller Replacement - Ricoh A109 Service Manual

6.3 FEED ROLLER REPLACEMENT

[A]
1. Turn off the main switch then open the feed cover [A].
2. Remove the guide mylars [B] (1 screw each).
3. Remove the snap ring [C].
4. Slide the roller [D] to the rear.
5. Hold the feed roller [E] then slide the shaft to the front, then remove the
feed roller assembly as shown.
6. Remove the four snap rings [F], then remove the feed rollers.
7. Install the new feed rollers, then re-assemble the machine.
NOTE: When installing the feed roller, be sure that the one way bearing
(silver color) is located in the front side (the roller must rotate only
counter-clockwise when the shaft is fixed).
A109
[B]
[E]
[F]
[C]
7-18
[D]
FSM