Hot Roller Replacement - Ricoh A109 Service Manual

13.7 HOT ROLLER REPLACEMENT

[A]
[D]
1. Remove the oil blade (see Hot Roller Blade Replacement).
2. Press the two lock tabs and open the fusing exit cover.
3. Screw the pressure release screws [A] all the way in (one screw on each
side).
Do not touch the screws for the springs. These are
NOTE:
adjusted at the factory to maintain the proper nip band
width.
4. Remove the upper frame [B] (5 screws and 4 connectors).
5. Remove the fusing unit knob [C] (1 screw).
6. Remove the oil pump [D] (2 screws and 1 clamp).
7. Remove the oil tank [E].
8. Remove the front fusing lamp bracket [F] (1 screw) and the hot roller
brackets [G] (1 screw each).
A109
[B]
[E]
[C]
5-100
[F]
[G]
FSM