Controller Menu - Danfoss MCO 305 Design Manual

MCO 305 Design Guide

Controller Menu

This menu provides various functions used to view
and set the controller configuration and to manage
various aspects of the controller's onboard memory.
This includes functions to manage saved programs
(and mark programs for Autostart), view and set
global and axis parameters, and save and reset the
controller EPROM memory.
Programs
Click on Controller → Programs to see all the programs currently stored on the controller in permanent
memory. You can also select other currently connected controllers to see (and manage) the programs on
those controllers.
NB!:
If "Binary file support" in Settings → Options is enabled, then the window shown on the right is
displayed. Otherwise, the window on the left is displayed.
Under Programs is a list of all programs currently saved on the controller. Each program will be identified by
a program number and a program name. Depending on available memory and the size of the saved
programs, up to 91 programs may be saved at any one time. If a program has been designated as the
Autostart program, then a
included on the controller, then a checkmark will appear in the Source column.
70
__ PC Software Interface __
will appear in the Autostart column. If source code for a program has been
®
MG.33.L5.02 – VLT is a registered Danfoss trademark