Danfoss MCO 305 Design Manual page 74

MCO 305 Design Guide
Parameters
The parameters in the Controller menu are divided
into two groups: the global parameters and the axis
parameters. Please see for more details, parameter
values, and the default settings the chapter
Parameter Reference.
Or simply press [F1] when the text cursor is in one
of the input fields and information about the corres-
ponding parameter will be displayed.
Parameters > Global
The global parameters include the functions of the
inputs and outputs and the standard parameters
which are group in 33-5* and 33-8*.
Select the controller you wish to edit. Then change
the desired parameter values. Click on OK to load
the changes into the controller.
NB!:
Note that you can select a different con-
troller after changing values but before
clicking OK. If you do this, then the
changed values are written to the previous control-
ler and the new controller's values are read and
displayed in the fields.
Parameters > Axis
Select the controller you wish to edit and, select the
group of axis parameters from the following list:
− Basic Settings – par. Group 32-8*
− Encoder Data – par. Group 32-0*, 32-3*
− Predefined I/Os – par. Group 33-4*, 33-5*
− Homing – par. Group 33-0*
− Synchronization – par. Group 33-1*
− Sync Marker – par. Group 33-1*
− Position Regulation – par. Group 32-6*
Change the desired parameter values. You can
select a different parameter group and change those
parameters as well. Then click on OK to load the
changes into the FC 300.
NB!:
Note that you can select a different axis after changing values but before clicking OK. If you do
this, then the changed values for that axis are written to the controller and the values for the new
axis are read and displayed in the fields. The same is true if you select a different controller: The
current values are written and then the new values are read and displayed.
74
__ PC Software Interface __
Global Parameters dialog box.
®
MG.33.L5.02 – VLT is a registered Danfoss trademark