Danfoss MCO 305 Design Manual page 111

MCO 305 Design Guide
Expert mode WITHOUT an Array Definition File
The stand-alone Array Editor Expert mode dialog is shown below. Use the toolbar icons, if the Array-Editor
has been started within the APOSS-IDE.
This dialog is used in the same way as the User mode dialog. The only difference is that Add and Delete
buttons are now available. However, since no Array Definition File has been loaded, the Array Editor expects
to work directly with the controller. As a result, the add and delete functions behave slightly differently than
they would if a file was loaded:
Add Array
will allow a new array to be added after the last existing array. The user will be prompted for the array
size.
NB!:
This new array will not be added to the controller until → Write to Controller is pressed.
Delete Array
will delete the currently selected array. Since "holes" (i.e. missing array numbers) are not allowed, all
arrays following the deleted array will be "renumbered" in order to close the gap left by the deleted array.
The array will not actually be deleted on the controller until → Write to Controller is pressed.
Note that only user arrays can be deleted; parameters cannot be deleted.
Add Index
will insert a single array index before the currently selected array index. If more than one array index is
selected, then the new index is inserted before the first selected index. If no index is selected, then the new
index is added at the end of the array. All array elements following the new index will be "renumbered" to
make room for the new index.
Note that new indices can only be added to user arrays.
Delete Index
will delete all of the currently selected array elements. If all array elements are selected, then the array
itself will be deleted. Since "holes" (i.e. missing array element numbers) are not allowed, all array elements
following the deleted elements will be "renumbered" in order to close the gaps left by the deleted elements.
The array elements will not actually be deleted on the controller until → Write to Controller is pressed.
Note that only user array elements can be deleted.
__ APOSS Tools __
®
MG.33.L5.02 – VLT is a registered Danfoss trademark
111