Danfoss MCO 305 Design Manual page 113

MCO 305 Design Guide
Expert mode WITH an Array Definition File
The stand-alone Array Editor Expert mode dialog when an array definition file is being used is shown below.
Use the toolbar icons, if the Array-Editor has been started within the APOSS-IDE.
This dialog is used in the same way as the User mode dialog. The difference is that Add and Delete buttons
are now available and that columns other than the "Value" column may be edited. As well, group headings
and disabled list items (i.e. items that do not exist on the controller) may be selected. This allows those
lines to be selected for the purposes of adding and deleting index lines. However, since an Array Definition
File has been loaded, the Array Editor expects to work with the file rather than with the controller. As a
result, the add and delete functions behave slightly differently than they would if a file was not loaded:
Add Array
will allow a new array to be added. The user will be prompted for the array number and array size. If no
arrays have been read from the controller, then the new array elements will all be enabled. If arrays have
been read from the controller, then the new arrays elements will be enabled or disabled according to
whether or not they exist in the arrays read from the controller.
Note that adding arrays will add the arrays to the array definition file only; the arrays will not be added to
the controller.
Delete Array
will delete the currently selected array from the array definition file. The array will not be deleted from
the controller. Deleting an array in this case, is simply equivalent to removing user access to the array.
NB!:
When the array definition file is being edited, User, Global, Axis, etc., arrays can be deleted.
Add Index
will insert a single array element before the currently selected array element. If more than one array
element is selected, then the new element is inserted before the first selected element. If no element is
selected, then the new element is added at the end of the entire list. A dialog will be displayed allowing the
user to specify exactly what kind of element is to be added.
Delete Index
will delete all of the currently selected array elements from the array definition file. The array elements
on the controller will not be changed. Deleting array elements in this case, is simply equivalent to removing
user access to those elements.
__ APOSS Tools __
®
MG.33.L5.02 – VLT is a registered Danfoss trademark
113