Danfoss MCO 305 Design Manual page 252

MCO 305 Design Guide
Error LCP display
no.
102 Too many CAN objects
103 Illegal axis num.
105 Error not reset
106 Home not done
107 Home vel. zero
108 Position error
109 Index not found
110 Unknown com.
111 SW end limit
112 Unknown param.
113 FC not enabled
114 Too many loops.
115 Par. save failed
116 Param. memory
117 Progr. Memory
118 Reset by CPU
119 User abort
121 No more SDO chn
125 HW end limit
149 Too many inter.
150 No ext. 24 V
151 Too many gosub
152 Too many return
154 D. out overload
155 LINK failed
156 Illegal double arg.
160 Internal Intr. error
162 Memory error
170 Too many DIM arrays
171 Array too small
175 Out of array mem.
176 Array size wrong
179 WAITNDX TO
184 Too many ontime
187 Out of memory
188 CAN guarding error
189 CAN send-receive error
190 Memory locked
191 Illegal cam array
252
__ Troubleshooting __
APOSS Error message
There are no more CAN objects available (CANINI).
Axis not in system.
Error not cleared.
Failed to move to HOME position.
Home velocity 0
Position error.
Index pulse (encoder) not found.
Unknown command.
Software end limit activated.
Illegal parameter number.
VLT Error Status
Too many nested loops.
INLONG command got an illegal string
Parameters in memory are corrupted.
Programs in memory are corrupted.
Reset by CPU.
User abort.
Number of SDO channels exceeded.
Limit switch activated.
Too many interrupt functions.
External supply is missing.
Too many nested GOSUB commands
Too many RETURN commands.
Digital output overloaded.
LINKGPAR failed.
A floating point function was called with an invalid argument.
Interrupt happened, but interrupt address is no longer valid.
Error in verifying
Too many DIM arrays defined.
Array too small
No more memory space for the new array defined by DIM.
Array size does not correspond to the size of the existing array.
Timeout while waiting for index.
Too many ONTIME or ONPERIODS interrupts.
Not enough memory for variables
A guarding error happened.
CAN send or receive error.
Memory locked
Illegal curve array in SETCURVE.
®
MG.33.L5.02 – VLT is a registered Danfoss trademark