Danfoss MCO 305 Design Manual page 75

MCO 305 Design Guide
Parameters > Name
This function allows you to assign a name to a
controller or to change the existing name of a
controller. The name is displayed in various dialogs
in the APOSS user interface, allowing you to more
easily differentiate between multiple controllers.
Click on Controller → Parameters → Name and
select the controller that you want to name. Enter a
name in the field and click on OK. Names cannot be
longer than 8 characters and must be uppercase.
NB!:
Note that you can select a different controller after changing the name but before clicking OK.
If you do this, then the changed name is written to the previous controller and the new controller's
name is read and displayed.
Parameters > Save to file
For backup purposes, the entire controller configura-
tion (i.e. global parameters, axis parameters, user
parameters, and arrays) can be uploaded and saved
as a file on the PC.
This file can then be downloaded again to the
controller at a later time if it becomes necessary to
restore the configuration
Select the controller, click on → Save, and then enter a name in the subsequent "Save As" dialog. If the
parameters of multiple controllers are to be saved, then simply select another controller and → Save again.
Parameters > Restore from file
If a controller's configuration has been backed up as
a file on the PC, then the configuration can be
restored to the controller again by downloading the
configuration file.
Click on Parameters → Restore from file. This will
display an "Open" dialog. Select the file containing
the data to be loaded. In the subsequent dialog,
select the FC 300 into which the data should be
loaded. Use the checkboxes to specify which sets of
parameters are to be loaded. Then click the →
Restore button. The specified parameters are then
loaded into the FC 300. Any previous parameter
values are overwritten.
If the same data is to be loaded into more than one
FC 300, then simply select another FC 300 and click
→ Restore from file again.
__ PC Software Interface __
®
MG.33.L5.02 – VLT is a registered Danfoss trademark
75