Danfoss MCO 305 Design Manual page 149

MCO 305 Design Guide
Adding Curves from other Oscilloscope Files
Curves defined in other Oscilloscope ".zbo" files can
be copied into the current Oscilloscope by selecting
the File tab.
Note: This feature is only available if the "User
Mode" is set to "Expert" (see Settings → Options).
Filename
This is the Oscilloscope file containing the curves
that will be copied. The Browse button can be used
to select the Oscilloscope file.
Curve list
This is a list of the curves found in the selected Oscilloscope file.
Select the curve to be copied by clicking on it with the left mouse button. Multiple curves can be selected by
holding the [Ctrl] key down while clicking on the curve. Some curves rely on the presence of other curves
and cannot be copied as stand-alone curves. For example, a derivative curve cannot be copied without also
copying the curve from which it is derived. Similarly, all curves in a group must be copied together. If the
user selects one of these curves, then the other required curves will be automatically selected as well.
NB!:
Note that the list will contain only those curves in the selected Oscilloscope file that are compatible
with the current Oscilloscope. For example, if the selected Oscilloscope file contains Single Shot
groups, then these groups will not be in the list if the current Oscilloscope is a Free Run
Oscilloscope.
__ APOSS Tools __
®
MG.33.L5.02 – VLT is a registered Danfoss trademark
149