Danfoss MCO 305 Design Manual page 88

MCO 305 Design Guide
__ PC Software Interface __
Displaying and Modifying Variables
At any time while the debugger is active (i.e. whether the program is executing or stopped), the current
value of any program variable can be displayed.
This is done by clicking on (or immediately after)
any instance of the variable with the left mouse
button.The current value will be displayed in a
yellow popup box. The value will be displayed until
the mouse is moved away from the variable. An
example is shown where the mouse button was
clicked near the variable "i" in the "print" statement.
At any time while the debugger is active, the
current value of any program variable can also be
modified. This is done by clicking on (or imme-
diately after) any instance of the variable with the
right mouse button.
The dialog shown will be displayed allowing the user
to modify the variable value.
88
®
MG.33.L5.02 – VLT is a registered Danfoss trademark