Select Wireless Network To Be Used For Wireless Bridge; Configure Ecl Comfort 296 / 310 Controller To Local Network - Danfoss ECL Comfort 296 Operating Manual

Operating guide

3.5 Select wireless network to be used for wireless bridge

The Netgear wizard asks for wireless network to be used by the wire-
less bridge. Select the wireless network.
The Netgear wizard now asks for the password to the selected wire-
less network. Enter the password.
The wireless bridge is then completing the configuration and the
ethernet connection on the side of the wireless bridge can now be
connected to the ECL Comfort 296 / 310.
3.6 Configure ECL Comfort 296 / 310 controller to local net-
work
The ECL Comfort 296 / 310 controller must be configured to con-
nect to the local network (LAN).
If the ECL Portal is used as SCADA system then the ECL Comfort
296 / 310 must be configured for DHCP instead of STATIC in the
System>Ethernet menu and the ECL Portal feature must be ena-
bled in the System>Portal Config menu.
4 | © Danfoss| 2021.01
ECL 296 / 310 Comfort to WLAN
Enter passphrase for the selected wireless network.
If used with ECL Portal: Configure for DHCP.
Enable the ECL Portal in the Portal Config menu.
AQ070386470176en-010301