Danfoss MCO 305 Design Manual page 101

MCO 305 Design Guide
__ APOSS Tools __
Correction
Display the positions where the master correction should begin and end (defined in the Curve Data index
card). This is displayed as a blue-grey bar along the bottom axis of the curve profile diagram.
Continuous Recalc
If this flag is checked, then the curve profiles will be continuously recalculated and redisplayed as Fix points
are dragged in the curve profile diagram. This redrawing of the curve may require a significant amount of
processing power. If this redrawing behaves erratically or creates a disruption on your computer, then you can
deactivate it; the curve will then be recalculated and displayed as soon as you release the mouse button.
Auto Scale
If this flag is checked, then the curve profile diagram will be automatically re-scaled so that the entire curve
is always visible.
Note that if the diagram has been manually zoomed or scrolled, then this flag will be automatically cleared
so that the user's area of interest will remain visible.
Snap on Grid
If this flag is checked, then Fix points will be snapped to the nearest interpolation grid point whenever they
are moved. It is recommended that this flag always be checked. Fix points which do not fall on interpolation
points, will not lie on the curve profile.
Note that the last fixpoint is always snapped to the interpolation grid, regardless of this flag, so that the pro-
per relationship can be maintained between the master cycle length and the number of interpolation points.
Mouse accuracy
If the right mouse button is pressed while the mouse is pointing at a Fix point, then the Fix point popup
menu is displayed. Otherwise, the normal popup menu is displayed. This value specifies how near to a Fix
point the mouse must be before the CAM-Editor will recognize that the mouse is pointing at that Fix point.
Note that a "hand" mouse icon (rather than the normal arrow mouse icon) will be displayed when the CAM-
Editor has determined that the mouse is pointing at a Fix point. That Fix point will also be highlighted in the
Fix Point Table so that the user can positively identify the point.
101
®
MG.33.L5.02 – VLT is a registered Danfoss trademark