Danfoss MCO 305 Design Manual page 129

MCO 305 Design Guide
The width will specify the number of points on either side of each point that will be used in the averaging.
For example, a width of 2 means 2 points on the left and 2 points on the right of each point for a total of
5 points in each averaged point.
NB!:
Warning: Care must be taken to avoid setting the smoothing width any higher than necessary. For
example, if a width of 2 gives satisfactory results, then do not use a width of 4. As the width is set
higher and higher, "real" information in the curve will begin to be "averaged away" and lost.
Unit string
An optional "Units" string can be set for each curve.
Users can either enter their own string or use the
drop-down box to select one of the predefined
strings. The string will appear in the "Units" column
in the "Curve Selection List".
__ APOSS Tools __
®
MG.33.L5.02 – VLT is a registered Danfoss trademark
129