Danfoss MCO 305 Design Manual page 123

MCO 305 Design Guide
__ APOSS Tools __
The "Name" column consists of three parts:
Checkbox – If this is checked, then this curve will be displayed in the Chart and Navigation Windows.
Otherwise, the curve is hidden. Left-clicking anywhere within the Name column will toggle the checkbox.
Color patch – This shows the color being used for the curve in the Chart and Navigation Windows. The color
is one of the curve properties that can be changed by the user.
Name – The name of the curve. This can also be changed by the user. Names with a grey background will
be headings that group together the following curves in the list.
Note that "Other Curves" is a special group and its name cannot be changed.
Popup Menu Functions for Name Column
Right-clicking anywhere in the Name column will
display the popup menu:
The top item in the list is simply the curve name for
reference only. It will always be grayed.
The other commands are as follows:
Rename – This command allows the user to rename the curve.
Reload & Redisplay – This command will "reload" the curve data from the controller and also redisplay the
data in the Chart Window.
Note that this will not always be possible, depending on the type of curve. The command will be grayed if
reloading is not possible.
Reload – This command will "reload" the curve data from the controller. Note that this will not always be
possible, depending on the type of curve. The command will be grayed if reloading is not possible.
Properties – This command is used to view and/or modify the properties of a curve. See Modifying a Curve's
Properties.
Shift to 0 – Curve data is collected based on the controller's system time. Since tests do not always start at
time 0, this command allows the start time to be toggled between 0 and the actual start time. This is similar
to the Shift to 0 toolbar button except that it is limited to the single selected curve.
Delete – This command will delete the selected curve.
Display ALL as Value – This command will change the display interpolation style of all curves to "Value". See
Modifying a Curve's Properties.
Show ALL – This command will display all curves in the chart. It can be used to avoid displaying all curves
one-by-one.
Hide ALL – This command will hide all curves in the chart. It can be used to avoid hiding all curves one-by-
one.
Grid Column
The "Grid" column consists of two columns of radio buttons.
123
®
MG.33.L5.02 – VLT is a registered Danfoss trademark