Danfoss MCO 305 Design Manual page 122

MCO 305 Design Guide
Using the Mouse in the Navigation Window
Left button (Zoom) - Zoom in to an area of interest in the chart by pressing the left mouse button, moving
the mouse across the area of interest, and then releasing the mouse button. The selected area will then be
displayed in the Chart Window.
NB!:
Note that the selected rectangle will be stretched so that it is exactly displayed in the window. If
stretching is not desired, then press and hold the [Ctrl] key before pressing the left mouse button.
Right button (Pan) - Pan across the chart (i.e. move the chart in the window) by placing the mouse any-
where within the black outline rectangle, pressing the right mouse button, moving the mouse, and then
releasing the mouse button. The chart in the Chart Window will follow the movement of the black outline
rectangle.
Curve Selection List
The "Curve Selection List" contains a list of all the curves that the user has defined and for which data have
been collected, along with various details (i.e. values, variables, states, etc.) about each curve. All the
properties of each individual curve, such as displaying, hiding, enabling, disabling, scaling, color, etc., are
controlled from this window.
The setting of all display properties, data collection properties, etc., is done using this list. If the list is too
long or too wide to fit within the window, then the associated scrollbars can be used to view other parts of
the list. Column widths can also be changed by dragging the column header separators with the left mouse
button. The figure below shows an example of the entire list.
Name Column
122
__ APOSS Tools __
®
MG.33.L5.02 – VLT is a registered Danfoss trademark