Danfoss MCO 305 Design Manual page 80

MCO 305 Design Guide
Simply select the appropriate interface type and change the necessary parameters.
NB!:
Note that only one interface type can be selected as the default interface. The default interface is
used to establish connections to controllers when the [Esc] key is pressed.
NB!:
Setting the interface parameters will affect only subsequent connections to controllers. Any
controller to which there is already an established connection, will remain connected and will not
be changed. If an established connection to a controller needs to be changed, then it will be
necessary to close the connection to that controller, change the interface settings, and then re-connect to
the controller.
Language
If you desire another language, click on Settings
the subsequent dialog field. → Exit program and start APOSS again. It is necessary to exit the program and
then restart again before the language change will take effect.
Editor Settings
In order to provide greater clarity, different colors
can be assigned to the various program elements
such as comments, key words, numbers, etc. Tab
settings can also be chosen to make the program
more readable.
Colors
Select the type of program element (e.g. Comment) and select the desired color.
Tab Settings
Choose the preferred tab size. This can be set to 2 or more.
Convert Tabs
Click on → Convert Tabs to spaces while typing to convert all tab characters to space characters while
typing. Note that this does not affect any tab characters that already exist in the program. Use Edit →
Convert Tabs if you want to convert all existing tabs in a program to spaces.
80
__ PC Software Interface __
Language and choose from the available languages in
®
MG.33.L5.02 – VLT is a registered Danfoss trademark