Danfoss MCO 305 Design Manual page 126

MCO 305 Design Guide
__ APOSS Tools __
Last, Minimum, and Maximum Columns
These columns will show the values listed below.
If a value is shown as "*", then the column is too narrow to display the entire value. In this case, the
column can be widened by dragging the column separator in the header with the left mouse button.
"Last" - The last recorded value of each curve.
"Minimum" - The minimum recorded value of each curve.
"Maximum" - The maximum recorded value of each curve.
Cursor A/B Columns
The column headings will contain the X coordinate (time) of the position of each cursor. When the cursors
are used, the value of each curve at the position of the cursor is shown in the columns "A" an "B": As well,
there will be a column containing the difference between the curve values at the cursor positions (i.e. the
value at cursor "B" minus the value at cursor "A").
As well, the If a value is shown as "*", then the column is too narrow to display the entire value. In this
case, the column can be widened by dragging the column separator in the header with the left mouse
button.
Units Column
An optional "Units" string can be defined by the user to each curve. This is described in Modifying a Curve's
Properties. If defined, then the Units string is displayed in this column. This string is solely for information;
it is not used by the Oscilloscope.
126
®
MG.33.L5.02 – VLT is a registered Danfoss trademark