Danfoss MCO 305 Design Manual page 153

MCO 305 Design Guide
Repeating the Test
Once Oscilloscope recording has been stopped, then the user is free to make any necessary changes,
additions, and deletions to the curves. Recording can be restarted simply by pressing the
again.
NB!:
Note that this will delete any previously recorded data. Previously recorded data will not be deleted
if the Pause toolbar button is used instead to the Stop button. In this case, a vertical red bar is
drawn in the chart at the position where the recording was paused.
Usage Notes for the TESTSETP Oscilloscope
Repeating a TESTSETP test is done entirely by the user outside the TESTSETP Oscilloscope. Once
completed, then the user has three options:
1. Open an entirely new TESTSETP Oscilloscope.
2. If the previous values are no longer needed, then the existing curves can be "reloaded". Do this by
right-clicking on the curve name in the "Curve Selection List" and selecting the Reload or Reload &
Redisplay command. The old values will be discarded and the new values will be loaded.
3. Add new TESTSETP curves using the
allows the new curves to be compared with the old curves. This can be done either visually or by
adding "derived" curves.
__ APOSS Tools __
Add curve toolbar button. This has the advantage that it
®
MG.33.L5.02 – VLT is a registered Danfoss trademark
Start button
153