Danfoss MCO 305 Design Manual page 82

MCO 305 Design Guide
__ PC Software Interface __
Array Editor parameter support
Normally, the Array Editor will read and display all user parameters and arrays. However, if this setting is
enabled, then the Array Editor will also read and display global parameters, temporary and permanent axis
parameters, axis process parameters, and system process parameters.
Create debug file
Enabling this option will cause APOSS to generate debug log files. This is normally useful only to product
support personal. This option should normally be disabled.
Protocol font
This is the type font that is used to display messages in the Communications Window. Changing this value
will only affect newly opened windows.
User Mode
The user mode allows APOSS to be tailored to the experience level of the user. Currently, this mostly applies
to the Oscilloscope function only.
Customized Sections
The SDO Lookup Tables allow more experienced users to customize the contents of the SDO selection lists
used in APOSS. For example, these are used in the Watch Window and the Oscilloscope.
The State Machine Program setting allows experienced users to use a customized state machine program in
the Tune Oscilloscope.
The Tune Oscilloscope Monitor File setting allows experienced users to use a customized test window in the
Tune Oscilloscope.
The Debug File Directory allows users to specify where debug log files are to be created.
Oscilloscope
This dialog allows you to select various options that control the behavior of APOSS oscilloscope tool. Please
see Oscilloscope for more detail.
82
®
MG.33.L5.02 – VLT is a registered Danfoss trademark