D/R,Exp - GRAUPNER mz-24 Pro Programming Manual

D/R,EXP

Infl uence of the control attitude of the control functions 2, 3 and 4
In the basic transmitter display, use your fi nger or the
provided stylus to touch the gear icon labeled "F":
000%
000:00.0
000 000
mz
0:01:23 000:00.0
Touch
M - 1
000 000
PHASE 1
MODELLNAME 1
BATT TIME 00: 01: 23
000
The display switches to the blue function menu. Touch
the menu item
"D/R,EXP".
BACK BASE FUNCTION
Phase D/R,EXP THR.CRV Prog.MIX
Touch
Logical sw Sequence
The dual rate/expo function allows you to switch or
infl uence the control defl ections and characteristics
for the control functions of the control functions 2 ... 4
through switch according to the phases. By otherwise
identical procedure the model specifi c differences
are related to the labeling of the respective value fi eld
right near the yellow "CH":
If the actually active model memory is confi gured as
"car", "boat" or "copter", then the setting pages of
this sub-menu are identifi ed as "CH2", "CH3" and
"CH4", for example:
124 Function menu | general - DR/Expo
000%
4.2V
000
If the actually active model memory is confi gured as
"helicopter", then the setting pages of this sub-menu
are identifi ed as "ROLL", "NICK" and "TAIL" instead
SYSTEM of "CH2", "CH3" and "CH4", for example:
Trainer
If the actually active model memory is confi gured as
"airplane" or "glider", then the setting pages of this
sub-menu are identifi ed as "AILE" (aileron), "ELEV"
(elevator) and "RUDD" (rudder) instead of "CH2",
"CH3" and "CH4", for example:
BACK PHASE 1 D/R,EXPO SERVO
CH CH 2
D/R +100% +100% INC
EXP 000% RES
000%
CTL NULL DEC
SYM OFF
BACK PHASE 1 D/R,EXP SERVO
CH AILE
D/R +100% +100% INC
RES
EXP 000% 000%
CTL NULL DEC
SYM OFF
BACK PHASE 1 D/R,EXP
CH AILE
D/R +100% +100%
EXP 000%
000%
CTL NULL
SYM OFF
Tip
An individual characteristic curve for control function 1
(Throttle/brake) can be set according to the model type
in the "THR.CRV" or "C 1 curve" menu, by means of
which 7 separately programmable points can be set.
Dual Rate acts, as the control setting in the sub-
menu "CTL Set", directly on the related
tion, independently from the fact that the function is
associated to a single servo or i actuated thorough a
complex mixer or coupling function by many different
servos.
The control defl ections can be set for each switch
position between 0 and 125% of the normal control
travel.
EXP allows a more sensitive control of the model in
the central position of the respective control function
for values greater than 0% without having to do with-
out the complete defl ection in the end position of the
control stick.
Conversely, the effect of the control around neutral
position increases for values less than 0% and de-
creases in the direction of the full defl ection. The pro-
gression can be set from -100% to +100%; 0% cor-
responds to the normal linear control characteristic.
There is another use for the most common rotary ser-
vos:
SERVO
INC
RES
DEC
Control func-