Samsung S5PC100 User Manual page 1387

TVOUT & VIDEO DAC
5.33
SDO CHANNEL CROSSTALK CANCELLATION COEFFICIENT FOR CH. 1 (SDO_XTALK1, R/W,
ADDRESS = 0XF000_ 0264)
SDO_XTALK1
Reserved
xtalk_coef12
Reserved
xtalk_coef10
5.34
SDO CHANNEL CROSSTALK CANCELLATION COEFFICIENT FOR CH. 2 (SDO_XTALK2, R/W,
ADDRESS = 0XF000_ 0268)
SDO_XTALK2
Reserved
xtalk_coef21
Reserved
xtalk_coef20
5.35
SDO BLACK BURST CONTROL REGISTER (SDO_BB_CTRL, R/W, ADDRESS = 0XF000_ 026C)
SDO_XTALK2
Reserved
ref_bb_level
Reserved
sel_bb_chan
Reserved
BB mode
9.7-66
Bit
[31:24] Reserved, read as zero, do not modify
[23:16] Same as xtalk_coef02
[15:8] Reserved, read as zero, do not modify
[7:0] Same as xtalk_coef02
Bit
[31:24] Reserved, read as zero, do not modify
[23:16] Same as xtalk_coef02
[15:8] Reserved, read as zero, do not modify
[7:0] Same as xtalk_coef02
Bit
[31:18] Reserved, read as zero, do not modify
[17:8] Black level setting value. It specifies the level during
horizontal active video for black burst signal.
The recommended values are
NTSC : 0x11A (include 7.5 IRE setup)
PAL : 0xFB (without setup)
[7:6] Reserved, read as zero, do not modify
[5:4] Black burst (BB) test channel selection
DAC0 DAC1 DAC2
00 = CVBS
01 = BB
10 = BB
11 = reserved
[3:1] Reserved, read as zero, do not modify
[0] Black burst test mode enable. If set, all of the bit fields in
SDO_CONFIG register except 'Selection of Video Mux for
DAC 0, 1, and 2' bit are discarded and SDO enters black
burst test mode. In order to enable black burst test,
'Selection of Video Mux for DAC 0, 1, and 2' bit has to be set
to zero.
Description
Description
Description
BB BB
CVBS BB
BB CVBS
S5PC100 USER'S MANUAL (REV1.0)
Reset Value
Reset Value
Reset Value
0
00
0
00
0
00
0
00
0
0x11A
0
00
0
0