Samsung S5PC100 User Manual page 1514

HDMI
3.30 THE START POSITION OF HDCP ENABLE
(SEND_START_0, R/W, ADDRESS = 0XF030_ 00F0)
SEND_START_0
SEND_START_0
3.31 THE START POSITION OF HDCP ENABLE
(SEND_START_1, R/W, ADDRESS = 0XF030_ 00F4)
SEND_START_1
SEND_START_1
3.32 THE END POSITION OF NOT SEND PERIOD
(SEND_END_0, R/W, ADDRESS = 0XF030_ 0100)
SEND_END_0
SEND_END_PD_L
3.33 THE END POSITION OF NOT SEND PERIOD / THE END POSITION OF HDCP ENC_EN SIGNAL
(SEND_END_1, R/W, ADDRESS = 0XF030_ 0104)
SEND_END_1
SEND_END_ENC_L
SEND_END_PD_H
3.34 THE END POSITION OF HDCP ENC_EN SIGNAL
(SEND_END_2, R/W, ADDRESS = 0XF030_ 0108)
SEND_END_2
Reserved
9.10-32
Bit
[7:0] The start positon of HDCP enable (Lower part)
Before getting an authentication we have not to send data for
16cycles from 512 to 528 (rising to rising)
Bit
[7:0] The start positon of HDCP enable (Upper part)
Before getting an authentication we have not to send data for
16cycles from 512 to 528 (rising to rising)
NOTE: Recommend value of SEND_START_0/1 is 513d
Bit
[7:0] The end positon of not send period (Lower part)
Don't send data period with SEND_START, After this period
hdmi control block should apply to HDCP block an
encryption enable signal with one clock duty from setting
SEND_END_ENC_H/L
Bit
The end position of HDCP ENC_EN signal (Lower part)
[7:2]
[1:0] The end position of not send period (Upper part)
NOTE: Recommend value of SEND_END_PD_H/L is 529d
Bit
Reserved
[7:4]
S5PC100 USER'S MANUAL (REV1.0)
Description
Description
Description
Description
Description
Reset Value
0x000
Reset Value
0x000
Reset Value
0x0FF
Reset Value
0x3F
0x3
Reset Value
0x0