Post-Processed Static Reference On Pillar - Leica GPS1200+ Technical Reference Manual

Geodetic satellite receiver

Hide thumbs Also See for GPS1200+:

Table of Contents

Equipment Setup

Post-Processed Static Reference on Pillar

The equipment setup described below is to be used for static operations on fixed surveying

The receiver and the RX1200 if used can be assembled to make one unit. One connection

is needed to connect the GNSS antenna which is mounted on the pillar to the receiver. The

receiver and the RX1200 can be kept in the container. Note that the receiver can be

programmed with the RX1200 prior to use which can then be omitted from the setup.

GNSS antenna is mounted directly using screw fitting. If using stub and adapter, proce-

dures may vary slightly.

GNSS antennas are AX1201 or AX1203+ GNSS. Procedures may vary if

AR25/AT504 GG is used.