Unit Assembly - Suzuki Grand Vitara XL-7 Service Manual

Hide thumbs Also See for Grand Vitara XL-7:

Table of Contents

7B1-106 AUTOMATIC TRANSMISSION (4 A / T)

UNIT ASSEMBLY

1) After applying A/T fluid to new O-rings, install them to reverse

brake piston (3), reaction sleeve (2) and secondary reverse pis-

2) install reverse brake piston assembly and brake piston return

spring to transmission case, using care not to damage O-ring.

Then install snap ring (1) with special tool.

Special tool

(A): 09926-98320

(B): 09941-84510

D Install so that opening in snap ring (1) will not align with

any of 3 lugs of spring seat.

D Do not compress spring more than necessary and do not

allow it fall or tilt.

3) Prepare a stand as shown in the figure. It is necessary because

work will be done with transmission case set upright from this

D To protect transmission case against damage, spread

cloth on stand where case contacts.

D A stand of such size as shown in figure will facilitate work.

4) Install thrust output shaft bearing and thrust bearing output shaft

race after lubricating them with grease.

Make sure that thrust bearing output shaft race is installed

in proper direction.

Table of Contents