Suzuki Grand Vitara XL-7 Service Manual page 481

7B1-76 AUTOMATIC TRANSMISSION (4 A / T)
1. Drive plate
2. Torque converter
3. Automatic transmission
4. Transfer
5. Engine rear mounting
6. Engine rear mounting member
Tighten bolts and nuts to specified torque.
CAUTION:
Do not reuse drive plate bolts. Otherwise, engine oil may
leak. Be sure to use new bolts with pre-coated adhesive.
"A": Sealant 99000-31110
Tightening torque
Torque converter mounting bolts (a):
.
65 N m (6.5 kg-m, 47.0 lb-ft)
Transmission to engine bolts and nuts (b):
.
61 N m (6.1 kg-m, 44.0 lb-ft)
Drive plate bolts (c):
.
50 N m (5.0 kg-m, 36.5 lb-ft)
Engine rear mounting bolts (e):
.
50 N m (5.0 kg-m, 36.5 lb-ft)
Engine rear mounting member bolts (e):
.
50 N m (5.0 kg-m, 36.5 lb-ft)
Exhaust No.1 pipe to manifold nuts:
.
50 N m (5.0 kg-m, 36.5 lb-ft)
Exhaust No.2 pipe to No.1 pipe bolts:
.
50 N m (5.0 kg-m, 36.5 lb-ft)
Muffler to exhaust No.2 pipe nuts:
.
60 N m (6.0 kg-m, 43.5 lb-ft)
Front propeller shaft universal joint flange bolts:
.
50 N m (5.0 kg-m, 36.5 lb-ft)
Rear propeller shaft universal joint flange bolts:
.
60 N m (6.0 kg-m, 43.5 lb-ft)
Oil filler tube bolt: 23 N
Select cable bracket bolts: 23 N
Stabilizer bar mount bush bracket bolts:
.
23 N m (2.3 kg-m, 17.0 lb-ft)
Clamp wiring harness and hoses securely.
Refer to "SELECT CABLE" in this section for adjusting procedure
of select cable.
Follow fluid level check procedure for refilling automatic transmis-
sion fluid and its level adjusting.
Connect battery, and confirm that engine and transmission func-
tion acceptably.
When remounting drive plate, use specified bolts.
.
m (2.3 kg-m, 17.0 lb-ft)
.
m(2.3 kg-m, 17.0 lb-ft)