Suzuki Grand Vitara XL-7 Service Manual page 252

6A3-54 ENGINE MECHANICAL (RHZ ENGINE)
6) Install main bearing cap No.2 (1).
7) Apply sealant to the end of cylinder block as shown in figure.
"A" Sealant: 99000-31140
8) Fit new bearing cap seal (1) to main bearing cap No.1 (2).
9) Attach special tools (A) and (B) to main bearing cap No.1 by us-
ing bolt and washer (3).
Special Tool
(A): 09911-16510 /OUT0000002
(B): 09913-96510 /OUT0000012
10) Apply oil to shims and their contact surface on block.
11) Install main bearing cap No.1 according to the following proce-
dure.
a) Engage cap into block at a 45_ angle.
b) Straighten it out.
c) Lower it slowly into block.
d) Remove bolt that holds special tool to cap.
e) Tighten both main bearing cap bolts temporarily.
f) Remove special tool straight out toward flywheel.
12) Cut side seals so that they protrude from cylinder block about
2 mm (0.08 in.).