Suzuki Grand Vitara XL-7 Service Manual page 515

7B1-110 AUTOMATIC TRANSMISSION (4 A / T)
1. Oil pump side
2. Over drive clutch cylinder side
19) When clutch disc or plate has been replaced, check height dif-
ference between O/D case and O/D clutch cylinder by mea-
suring it as shown in the figure.
Standard height difference "a" between O/D case and O/D
clutch cylinder:
About 3.5 mm (0.138 in.)
NOTE:
Measure at the highest point along inner circumference of
O/D clutch cylinder.
20) Apply A/T fluid to new housing O-ring and install it to O/D case.
Then install converter housing and tighten housing bolt to spe-
cified torque.
Tightening torque
Torque converter housing No.1 bolts (a):
.
35 N m (3.5 kg-m, 25.5 lb-ft)
Torque converter housing No.2 bolts (b):
.
58 N m (5.8 kg-m, 42.0 lb-ft)
21) Apply grease to thrust front race and install it to O/D clutch cyl-
inder.
22) Apply grease to front bearing assembly and install it to oil pump
assembly. Also, apply A/T fluid to new oil pump cover O-ring
and install it to oil pump assembly. Then install oil pump assem-
bly aligning bolt holes in O/D case with those in transmission
case oil pump assembly. Apply seal packing to oil pump as-
sembly bolts and tighten them by certain amount of torque at
each time one after another till specified torque is attained.
Tightening torque
Oil pump assembly bolt (a): 22 N
.
m (2.2 kg-m, 16.0 lb-ft)