Suzuki Grand Vitara XL-7 Service Manual page 251

INSTALLATION
NOTE:
D All parts to be installed must be perfectly clean.
D Be sure to apply oil to crankshaft journals, journal bearings,
thrust bearings, crankpins, connecting rod bearings, pis-
tons, piston rings and cylinder bores.
D Journal bearings, bearing caps, connecting rods, rod bear-
ings, rod bearing caps, pistons and piston rings are in com-
bination sets. Do not disturb such combination and make
sure that each part goes back to where it came from, when
installing.
1) Install main bearings (1) to cylinder block.
One of two halves of main bearing, has an oil groove (2). Install
it to cylinder block, and the other half without oil groove to bear-
ing cap.
2) Install thrust bearings (1) to cylinder block between No.1 and
No.2 cylinders. Face oil groove (2) sides to crank webs.
3) Install crankshaft to cylinder block.
4) Install main bearing caps No.3 (1), No.4 (2) and No.5 (3).
5) Install thrust bearing (4) so that its oil groove faces flywheel side.
ENGINE MECHANICAL (RHZ ENGINE) 6A3-53