Suzuki Grand Vitara XL-7 Service Manual page 517

7B1-112 AUTOMATIC TRANSMISSION (4 A / T)
29) Align hole in manual shift shaft with that in manual shift lever
30) Align hole in sleeve cover with dent in manual shift lever and
31) With parking lock rod (1) installed to manual shift lever, place
32) Apply A/T fluid to new O-rings and install them to accumulator
4. Upper spring
5. Lower spring
6. Coil outer diameter
and drive in new manual shift lever pin (1).
caulk securely with pin punch (1). Then check that manual shift
shaft turns smoothly.
parking lock rod (1) on parking lock pawl (2) as shown in the
figure. Then install pawl bracket and tighten bracket screw to
specified torque.
Tightening torque
Pawl bracket screw: 7.5 N
pistons (1, 2, 3) and install accumulator pistons to transmission
case.
.
m (0.75 kg-m, 5.5 lb-ft)