Unit Assembly - Suzuki SQ416 Service Manual

7B1-14 AUTOMATIC TRANSMISSION (4 A / T)
400 mm
(15.7 in.)
35 mm (1.4 in.)

UNIT ASSEMBLY

1) After applying A/T fluid to new O-rings, install them to reverse
brake piston (3), reaction sleeve (2) and secondary reverse pis-
ton (1).
2) Install reverse brake piston assembly and brake piston return
spring to transmission case, using care not to damage O-ring.
Then install snap ring (1) with special tool.
Special tool
(A): 09926-98320
(B): 09941-84510
NOTE:
D Install so that opening in snap ring (1) will not align with
any of 3 lugs of spring seat.
D Do not compress spring more than necessary and do not
allow it fall or tilt.
3) Prepare a stand as shown in the figure. It is necessary because
work will be done with transmission case set upright from this
up
step on.
NOTE:
D To protect transmission case against damage, spread
cloth on stand where case contacts.
D A stand of such size as shown in figure will facilitate work.
350 mm
(13.8 in.)
4) Install thrust output shaft bearing and thrust bearing output shaft
race after lubricating them with grease.
NOTE:
Make sure that thrust bearing output shaft race is installed
in proper direction.