Suzuki Grand Vitara XL-7 Service Manual page 373

36) Remove C-ring (1) of counter shaft bearing and C-ring (2) of
main shaft bearing.
Special tool
(A): 09900-06107
37) Pull off input shaft assembly (1), main shaft assembly (2) and
counter shaft assembly (3) together from intermediate case (4)
as shown in the figure.
NOTE:
When input shaft assembly (1), main shaft assembly (2)
and counter shaft assembly (3) can't be pulled off by hand
from intermediate case (4), pull off them by tapping lightly
both the rear of main shaft and counter shaft alternately
using a plastic hammer, taking care the counter shaft as-
sembly (3) does not fall off.
38) Remove input shaft assembly (1) with synchronizer ring from
main shaft assembly (2).
NOTE:
When removing input shaft, be careful not to drop bearing.
MANUAL TRANSMISSION 7A2-25