Suzuki Grand Vitara XL-7 Service Manual page 493

7B1-88 AUTOMATIC TRANSMISSION (4 A / T)
DISASSEMBLY
1) After removing retaining ring (1), remove direct clutch input hub
(2) and forward clutch hub (3).
2) Remove bearing race and thrust bearing.
1. Thrust bearing
No.2
2. Thrust forward
clutch bearing
3. Thrust rear race
3) Install direct clutch input hub (1) and retaining ring (2).
4) Install forward clutch (2) to O/D case (1). Apply 4 – 8 kg/cm
pressure into fluid hole at the right of cut in O/D case and mea-
sure movement of forward clutch piston.
If measured value is not within standard range, adjust it to stan-
dard value with selective clutch plates shown below.
Standard forward clutch piston movement:
1.40 – 1.70 mm (0.056 – 0.067 in.)
Available plate thickness
5) Remove retaining ring (1) and then remove direct clutch input
hub.
6) Remove retaining ring and then remove all clutch discs.
1.8, 2.0 mm (0.071, 0.079 in.)
2
air