Suzuki Grand Vitara XL-7 Service Manual page 558

1. Torque wrench
2. Differential case assembly
3. Aluminum plate
4. Vise
6) Clean and degrease mating surface of drive bevel gear (hypoid
gear) (1).
7) Apply thread lock cement to hatched part of drive bevel gear (1)
as shown in the figure.
"A": Cement 99000-32110
8) Put drive beval gear (3) on differential case (1) and fasten them
with bolts (2) by tightening them to specified torque.
Use thread lock cement for bolts (2).
CAUTION:
Use of any other bolts than that specified is prohibited.
"A": Cement 99000-32110
Tightening torque
Bevel gear bolts (a): 95 N
9) Install special tool to differential case assembly and check that
preload is within specification below. If preload exceeds speci-
fied value, check if foreign matter is caught or gear is damaged.
Special tool
(B): 09928-06510
Side gear preload
.
: Max. 2.5 N m (0.25 kg-m, 1.8 lb-ft)
DIFFERENTIAL (REAR) 7F-11
.
m (9.5 kg-m, 68.5 lb-ft)