Suzuki Grand Vitara XL-7 Service Manual page 519

7B1-114 AUTOMATIC TRANSMISSION (4 A / T)
36) Clamp wire harness (1) by wire harness clamp (2).
37) Install transmission temperature sensor (3) to sensor clamp
(4).
38) Connect the following connector by referring to its color shown
below.
D Shift solenoid-A (No.1) connector (5) – Brown
D Shift solenoid-B (No.2) connector (6) – Black
D TCC (lock up) solenoid connector (7) – White
D Pressure control solenoid connector (8) – Black
39) Install oil strainer (9).
Tightening torque
Oil strainer bolts (a): 10 N
40) Confirm two oil pan magnet (1) are in its place.
2. Oil pan
41) Install transmission oil pan with new oil pan gasket (2).
NOTE:
Align cut out (1) in oil pan gasket with that in transmission
case.
Tightening torque
Transmission oil pan bolts:
4.5 N
42) With wood rough key attached to output shaft, install sensor ro-
tor by aligning its key groove with wood rough key and install
C-ring by using special tool.
Special tool
(A): 09920-76010
1. Retaining ring
.
m (0.1 kg-m, 7.5 lb-ft)
.
m (0.45 kg-m, 3.5 lb-ft)