Suzuki Grand Vitara XL-7 Service Manual page 355

3) If control lever locating bolts (1) are replaced or retightened,
torque them as specified below.
Replacing of control lever locating bolts (1) requires thread lock
cement.
"B": Cement 99000-32110
Tightening torque
Control lever locating bolt (a):
.
17 N m (1.7 kg-m, 12.5 lb-ft)
4) Apply grease to pivot portions and seat, then install shift control
lever.
"A": Grease 99000-25010
5) Install transmission boot No.1 (1) from inside of cabin and clamp
it with a new clamp (2) securely.
6) Install transfer boot No.1 (1) securely on lift and clamp it by using
a new clamp (2).
7) Tighten transmission boot No.2 (2) with boot cover and console
box bracket (1).
Tightening torque
3
Control lever boot cover bolt (a):
.
15 N m (1.5 kg-m, 11.0 lb-ft)
8) Install console box.
NOTE:
Be sure that flare end of transmission boot No.3 (3) is en-
gaged with console box.
MANUAL TRANSMISSION 7A2-7