Suzuki Grand Vitara XL-7 Service Manual page 541

7E-10 DIFFERENTIAL (FRONT)
ACTUATOR
1) Disconnect air hose from pump assembly and install special tool
2) Connect compressor air hose to special tool.
1. Differential housing
2. Adjusting screw
3. To air compressor
3) With the vehicle lifted so that both of the front wheels are off the
to air hose as shown in figure. Loosen adjusting screw of special
tool.
Special Tool
(A): 09918-18111
Blow air and turn adjusting screw to obtain specified pressure.
Specified pressure: 30.0 kPa (0.3 kg/cm
CAUTION:
Do not apply a pressure exceeding 200 kPa (2.0 kg/cm
28.4 psi) which may cause damage to diaphragm.
ground, turn one of the front wheels by hand and check the other
wheel, which should act as described below.
D When the pressure from compressor is applied to actuator:
The other front wheel should turn in the direction opposite to
the wheel being turned by hand.
D When the pressure from compressor is not applied to actuator:
The other front wheel should remain stationary while the wheel
pushed by hand is turning.
If the result is not satisfactory, inspect differential assembly. Re-
fer to "INSPECTION" of SECTION 7E in UNIT REPAIR MANU-
AL.
2
, 4.25 psi)
2
,