Reset Absolute Encoder (Fn008) - YASKAWA SGD7S Product Manual

13.4.7

Reset Absolute Encoder (Fn008)

Refer to the following section for information on this utility function other than the procedure.
5.17 Resetting the Absolute Encoder on page 5-52
Panel Display after
Step
Operation
1
2
3
4
5
6
7
8 To enable the change to the settings, turn the power supply to the SERVOPACK OFF and ON again.
13.4 Utility Function (Fn) Operations on the Panel Operator
Keys
Press the MODE/SET Key to enter Utility Function
Mode.
MODE/SET DATA/
Press the UP Key or DOWN Key to display Fn008.
MODE/SET DATA/
Press the DATA/SHIFT Key for approximately one
second. PGCL1 will be displayed.
MODE/SET
Continue pressing the UP Key until PGCL5 is dis-
played.
Note: If you press the wrong key, no-oP will flash
on the display for approximately one second
MODE/SET DATA/
and the display will return to the original Util-
ity Function Mode display. Repeat the opera-
tion from the beginning.
Press the MODE/SET Key.
The absolute encoder will be initialized.
When initialization has been completed, donE will
MODE/SET DATA/
flash on the display for approximately one second.
After displaying donE, the display will return to the
–
PGCL5 display.
Press the DATA/SHIFT Key for approximately one
second to return the display to Fn008.
MODE/SET

13.4.7 Reset Absolute Encoder (Fn008)

Operation
13
13-17