Jog (Fn002) - YASKAWA SGD7S Product Manual

13.4.2

Jog (Fn002)

Refer to the following section for information on this utility function other than the procedure.
7.3 Trial Operation for the Servomotor without a Load on page 7-7
Panel Display after
Step
Operation
1
2
3
4
5
6
7
8 Turn the power supply to the SERVOPACK OFF and ON again after you finish jogging.
13.4 Utility Function (Fn) Operations on the Panel Operator
Keys
Press the MODE/SET Key to enter Utility Function
Mode.
MODE/SET DATA/
Press the UP Key or DOWN Key to display Fn002.
MODE/SET DATA/
Press the DATA/SHIFT Key for approximately one sec-
ond. The display shown at the left will appear.
MODE/SET DATA/
Press the MODE/SET Key to turn ON the servo.
MODE/SET DATA/
The Servomotor will operate at the speed set in Pn304
or Pn383 while the UP Key (for forward operation) or
MODE/SET DATA/ DOWN Key (for reverse operation) is pressed.
Press the MODE/SET Key to turn OFF the servo.
Additional Information
You can turn OFF the servo by pressing the DATA/
MODE/SET DATA/
SHIFT Key for approximately one second.
Press the DATA/SHIFT Key for approximately one sec-
ond to return the display to Fn002.
MODE/SET DATA/

13.4.2 Jog (Fn002)

Operation
13
13-13