13.4 Utility Function (Fn) Operations on the Panel Operator
13.4.1 Display Alarm History (Fn000)
13.4
Utility Function (Fn) Operations on the Panel Operator
Utility functions are used to set up and tune the SERVOPACK.
The Panel Operator displays numbers beginning with "Fn."
Display Example: Origin Search
The operating procedures from the Panel Operator are described here. Refer to the descrip-
tions of individual utility functions for preparations and related parameters.
Refer to the following section for details on utility functions.
15.2.1 Corresponding SERVOPACK Utility Function Names on page 15-7
13.4.1 Display Alarm History (Fn000)
Refer to the following section for information on this utility function other than the procedure.
12.2.4 Displaying the Alarm History on page 12-41
Step
1
2
3
4
5
6
7
8
13-12
Panel Display after
Operation
MODE/SET
MODE/SET
MODE/SET
MODE/SET
Alarm number
MODE/SET
MODE/SET
MODE/SET
MODE/SET
MODE/SET
Keys
Press the MODE/SET Key to enter Utility Function
DATA/
Mode. If Fn000 is not displayed, press the UP Key or
DOWN Key to display Fn000.
DATA/
Press the DATA/SHIFT Key for approximately one sec-
ond. The most recent alarm will be displayed.
DATA/
Press the DOWN Key to display the next older alarm.
Press the UP Key to display the next newer alarm. The
higher the far-left segment is, the older the alarm is.
Refer to the following section for information on
DATA/
alarms.
12.2.1 List of Alarms on page 12-5
Press the DATA/SHIFT Key. The lower four digits of
the time stamp will be displayed.
DATA/
Press the DATA/SHIFT Key. The middle four digits of
the time stamp will be displayed.
DATA/
Press the DATA/SHIFT Key. The upper two digits of
the time stamp will be displayed.
DATA/
Press the DATA/SHIFT Key. The alarm number will
flash on the display.
DATA/
Press the DATA/SHIFT Key again for approximately
one second to return the display to Fn000.
DATA/
Operation