Panel Operator; Panel Operator Key Names And Functions; Changing Modes - YASKAWA SGD7S Product Manual

13.1

Panel Operator

13.1.1

Panel Operator Key Names and Functions

The Panel Operator consists of a panel display and Panel Operator keys.
You can use the Panel Operator to set parameters, display status, execute utility functions, and
monitor SERVOPACK operation.
The Panel Operator key names and functions are given below.
13.1.2

Changing Modes

Press the MODE/SET Key to change between the modes as shown below.
Refer to the reference pages for the operating procedures in each function mode.
You can change the setting of Pn52F (Monitor Display at Startup) to display the Monitor Dis-
Information
play Mode instead of the Status Display Mode after the power supply is turned ON.
Set Pn52F to the Un number of the monitor display to display after the power supply is
turned ON.
If 0FFF is set (default setting), the SERVOPACK will enter the Status Display Mode after the
power supply is turned ON.
Panel display

Panel Operator

Power ON
Press the MODE/SET Key.
Press the DATA/SHIFT Key
for approx. 1 second.
Press the MODE/SET Key.
Press the DATA/SHIFT Key
for approx. 1 second.
Press the MODE/SET Key.
Press the DATA/SHIFT Key
for approx. 1 second.
Press the MODE/SET Key.
Monitor Display at Startup
Setting
Pn52F Setting Unit
Range
0000 to 0FFF

13.1.1 Panel Operator Key Names and Functions

Key
Key Name
No.
• Changes the display.
MODE/SET

• Confirms settings.
Key

UP Key Increases the setting.

DOWN Key Decreases the setting.
• Displays the setting. To display the
setting, press the DATA/SHIFT Key
DATA/SHIFT

for approximately one second.
Key
• Moves to the next digit on the left
when a digit is flashing.
Status Display Mode
Utility Function Mode (Fn)
Parameter Setting Mode (Pn)
Monitor Display Mode (Un)
Default
Setting
– 0FFF Immediately
13.1 Panel Operator
Function
page 13-4
page 13-12
page 13-6
page 13-8
Speed Position Torque
When
Classification
Enabled
Setup
13
13-3