Autotune Analog (Speed/Torque) Reference Offset (Fn009); Manually Adjust Speed Reference Offset (Fn00A); Manually Adjust Speed Reference Offset - YASKAWA SGD7S Product Manual
E-7s servopack with analog voltage/pulse train references
Hide thumbs
Also See for SGD7S:
- Product manual (629 pages) ,
- Selection manual (337 pages) ,
- Product manual (558 pages)
Table of Contents
Advertisement
13.4 Utility Function (Fn) Operations on the Panel Operator
13.4.8 Autotune Analog (Speed/Torque) Reference Offset (Fn009)
13.4.8 Autotune Analog (Speed/Torque) Reference Offset
(Fn009)
Refer to the following section for information on this utility function other than the procedure.
Automatically Adjusting the Torque Reference Offset on page 6-40
Step
1
2
3
4
5
6
13.4.9 Manually Adjust Speed Reference Offset (Fn00A)
Refer to the following section for information on this utility function other than the procedure.
Step
1
2
3
4
5
13-18
Automatically Adjusting the Speed Reference Offset on page 6-18
Panel Display after
Operation
–
MODE/SET
MODE/SET
MODE/SET
MODE/SET
MODE/SET
Manually Adjusting the Speed Reference Offset on page 6-21
Panel Display after
Operation
Keys
Turn OFF the servo, and input a 0-V reference voltage
–
from the host controller or an external circuit.
Press the MODE/SET Key to enter Utility Function
Mode.
DATA/
Press the UP Key or DOWN Key to display Fn009.
DATA/
Press the DATA/SHIFT Key for approximately one
second. rEF_o will be displayed.
Press the MODE/SET Key. donE will flash on the dis-
play for approximately one second, and then the dis-
DATA/
play shown on the left will appear.
Press the DATA/SHIFT Key for approximately one
second to return the display to Fn009.
Keys
Press the MODE/SET Key to enter Utility Function
Mode.
MODE/SET
DATA/
Press the UP Key or DOWN Key to display Fn00A.
MODE/SET
DATA/
Press the DATA/SHIFT Key for approximately one
second. The display shown on the left will appear.
Note: If write protection is set, no_oP will flash on
MODE/SET
Turn ON the servo from an external device. The dis-
–
play shown on the left will appear.
Press the DATA/SHIFT Key for approximately one
second. The current amount of offset will be dis-
played.
MODE/SET
Operation
Operation
the display for approximately one second.
Change the setting of Fn010 to enable writ-
ing.
Continued on next page.
Advertisement
Table of Contents
Troubleshooting
