Drive Assembly - Star Micronics WinType 4000 Technical Manual

REPLACEMENT AND ADJUSTMENT OF PARTS

2.7 Drive Assembly

[Disassembly]
Warning: Turn off the power switch and disconnect the power supply cord from the wall outlet.
Remove the EP toner cartridge and keep it in a safe place.
(1) Remove the following units:
• Feeder assembly (Refer to section 2.1)
• Fuser assembly (Refer to section 3.1)
• Rear cover (Refer to section 1.3)
• PJ14 [1]
Remove the three screws [2] securing the drive assembly and, while lifting the rear of the drive
assembly [3], remove it.
[4]
[Assembly]
Reverse the disassembly procedure.
Remove the bottom cover (refer to section 1.4) and be sure the HVPS terminal [4] on the drive assembly
Caution:
[3] is securely connected to the HVPS.
[3]
– 36 –
[1]
[2]