Feeder & Drive; Feeder Assembly - Star Micronics WinType 4000 Technical Manual

REPLACEMENT AND ADJUSTMENT OF PARTS
2. FEEDER & DRIVE

2.1 Feeder Assembly

[Disassembly]
Warning: Turn off the power switch and disconnect the power supply cord from the wall outlet.
Remove the EP toner cartridge and keep it in a safe place.
(1) Remove the top cover. (Refer to section 1.2)
(2) Remove the four screws [1] securing the feeder assembly [2].
(3) Disconnect PJ181 [3] from the pre-regi. sensor.
(4) Remove the rear cover. (Refer to section 1.3)
(5) Disconnect PJ16 [4] from the MUC PWB and remove the feeder assembly [2].
[6]
[Assembly]
Reverse the disassembly procedure.
When installing the feeder assembly [2] on the printer, be sure the harnesses [6] are not pinched between
Caution:
any other parts.
[1]
[3]
[4]
[2]
– 30 –
[1]